Parking Lot Sign Installation
In East Fort Worth, TX

ADA, Fire Lane, and Directional Signage

1-800-STRIPER® provides professional parking lot sign installation in East Fort Worth, TX — mounting ISA accessible-space signs with van-accessible plates, “NO PARKING FIRE LANE” and tow-away signs, and directional signage per the 2012 Texas Accessibility Standards and the Fort Worth Fire Code.

1-800-STRIPER® of East Fort Worth PROVIDes Signage Installations Services NEAR YOU

Are you communicating clearly?

We install new signs in adherence with local regulatory standards and can repair or replace damaged signs so you can clearly communicate your parking requirements.

  • Directional Signs
  • ADA Accessible
  • Reserved Parking
  • Veteran Parking
  • No Parking
  • Electric Vehicle Charging Station
  • Take-Out Only Signs
  • Parking Lot Sign Installation in East Fort Worth, TX

    1-800-STRIPER® of East Fort Worth mounts, replaces and re-posts parking lot signage across Fort Worth, Arlington and the Dallas–Fort Worth Metroplex: accessible-space signs, fire-lane and tow-away signs, and directional signs.

    Two of those are not decoration. Texas specifies the sign at an accessible space; the Fort Worth Fire Code specifies a fire-lane sign to the inch. Get either wrong and the paint on the pavement will not save you. Call (972) 543-1033.

    Accessible-space signage — what TAS 502.6 requires

    Every accessible space must be identified by a sign, and Section 502.6 of the 2012 Texas Accessibility Standards sets its spec:

    RequirementTAS 502.6
    SymbolInternational Symbol of Accessibility
    Van spacesIdentified “van accessible”
    Mounting heightBottom of sign 60 in minimum above finished floor or ground
    StatusBinding on a private commercial lot in Texas

    TAS attaches on new construction, alteration and change of occupancy. What an older, untouched lot must be brought up to is a safe-harbor question for a Registered Accessibility Specialist.

    The Texas add-on: 16 TAC § 68.104 and the “fine and towing” wording

    TAS 502.6 tells you the accessible-space sign must carry the symbol and, on a van space, the van designation. Texas adds one more line to it. Since 1 August 2020, 16 TAC § 68.104 has required that a paved accessible space also carry a sign identifying the consequences of parking there illegally — at minimum the words “Violators Subject to Fine and Towing,” in letters at least one inch tall.

    Requirement16 TAC § 68.104(a)(3)
    WordingAt minimum, “Violators Subject to Fine and Towing”
    Letter heightNot less than 1 in
    MountingPole, post, wall or freestanding board
    PositionNo more than 8 in below the TAS 502.6 sign
    HeightBottom edge 48–80 in above ground level
    Applies toNew construction and alterations beginning on or after 1 Aug 2020

    You do not automatically need a second post. Subsection (b) is explicit: an identification sign that already complies with TAS 502.6 and includes that wording satisfies the requirement on its own. Most signs already in the ground in Texas predate the rule and do not carry it, so the usual fix is a replacement face or an add-on plaque below the existing sign — but if your sign already says it, you are done, and we will tell you so.

    When it reaches you. § 68.104 is not retroactive. TDLR stated on the record that it lacks “the statutory authority under HB 3163 to make the rules retroactive,” and that “compliance with § 68.104 will be determined at the time of construction.” A lot that is simply sitting there, unaltered since before August 2020, is not out of compliance today. The rule attaches when you build or alter — resurfacing the lot, or a restripe that changes the accessible spaces or access aisles. A like-for-like repaint that reproduces your existing layout is treated as painting, which the standards do not count as an alteration unless it affects usability.

    Fire-lane and tow-away signs — the Fort Worth spec, to the inch

    Fort Worth writes the fire-lane sign into the code, dimension by dimension. Section 13-2 of the Fort Worth Fire Code, amending the adopted 2021 International Fire Code:

    ElementFort Worth Fire Code § 13-2
    LegendNO PARKING FIRE LANE
    Sign size12 in wide × 18 in high
    Companion signTOW AWAY ZONE — 12 in wide × 6 in high
    ColorWhite background, letters and borders in red
    LetteringNot less than 2 in
    MountingPermanently affixed to a stationary post
    HeightBottom of sign 6 ft 6 in above finished grade
    SpacingNot more than 50 ft apart, both sides
    StatusBinding

    Section 503.3 also puts an ongoing duty on the sign once it is up: signs and striping “shall be maintained in a clean and legible condition at all times and be replaced or repaired when necessary to provide adequate visibility.” A faded or missing fire-lane sign is a compliance failure, not a cosmetic one. Whether a fire lane is required at all is the fire marshal’s determination.

    No compliant sign, no citation — the sign is your enforcement

    At an accessible space, the sign is what makes enforcement possible. Texas Transportation Code Chapter 681, at § 681.011(f-2), provides that a peace officer “may issue a warning but may not issue a citation” to a person who parks in a space “that does not have a parking space identification sign” meeting the standard.

    The sign is not paperwork that follows enforcement — it is what enables it. Without a compliant one, the accessible space you paid to stripe can sit occupied all day, and the officer you called has nothing to write.

    Note what the statute turns on: the sign, not the pavement marking. Repainting a faded symbol does not restore an officer’s power to write the ticket. A compliant sign on a post does.

    Directional and regulatory signs — the conventions we build to

    Everything else — stop, do not enter, one way, reserved, visitor, drive-thru — is a legibility problem. We solve it with the Texas Manual on Uniform Traffic Control Devices R-series regulatory signs.

    The federal manual’s applicability section, 23 CFR §655.603(a), excludes parking areas and their driving aisles from what counts as a road open to public travel, so the MUTCD is not federally mandated for the bays and drive aisles of a private lot. We build to MUTCD and Texas MUTCD conventions because that is what your drivers already read — and a city’s site-plan standards may adopt them, so confirm it for your project. Your binding signage requirements at accessible spaces and fire lanes come from the 2012 Texas Accessibility Standards and the Fort Worth Fire Code.

    Get a free estimate

    Signage is quoted with the markings it goes with: the accessible stalls, the fire lane, and the line striping. We will inventory the signs that are faded, bent, mounted short, or missing. 1-800-STRIPER® of East Fort Worth is rated 4.6 stars from 9 Google reviews. Call (972) 543-1033.

    Code references verified against the published ordinance and standard on 13 July 2026. This is general information, not legal advice — confirm what applies to your property with the authority having jurisdiction.

    For a full list of our pavement marking services, visit our parking lot striping in East Fort Worth page.

    Businesses We Serve

    amazon
    Dunkin' Donuts
    mcdonalds
    walmart

    How it Works

    Step 1: Request a free parking lot striping estimate

    GET A FREE ESTIMATE

    Contact us today and we’ll have a quote to you in 24 hours

    Step 2: Get scheduled in 7 days

    SCHEDULE AN INSTALLATION

    We’ll have your installation scheduled in less than 7 days, without affecting your business hours

    Step 3: Professional striping crew arrives on-site

    GET A PARKING LOT THAT POPS

    For a budget-friendly price, you’ll get a parking lot that looks like new

    We proudly work with:

    Sherwin Williams
    Graco line striping equipment — used by 1-800-STRIPER

    We proudly work with:

    Sherwin Williams
    graco

    Frequently Asked Questions About Parking Lot Sign Installation in East Fort Worth, TX

    What does the sign at an accessible space have to show?

    Under TAS 502.6, an accessible parking space must be identified by a sign displaying the International Symbol of Accessibility, with the bottom of that sign a minimum of 60 inches above the finished floor or ground. Van spaces carry the “van accessible” designation. On a private commercial lot in Texas, that requirement binds.

    When does a space need a “van accessible” plate?

    When the space is a van space. On new construction and alterations, TAS 208.2.4 requires that for every six, or fraction of six, required accessible spaces, at least one be a van space — so a lot with a single required accessible space still needs that one to be a van space. Fort Worth’s table still shows one in eight, the older federal figure; where they differ, we build to TAS. It is designated “van accessible” on its sign.

    How high does a parking lot sign have to be mounted?

    It depends on the sign, and these heights get confused constantly. TAS 502.6 sets the accessible-space identification sign at a minimum of 60 inches, bottom of sign to finished floor or ground. 16 TAC § 68.104(a)(3) sets the “Violators Subject to Fine and Towing” sign with its bottom edge between 48 and 80 inches above ground level, and no more than eight inches below the identification sign. The Fort Worth Fire Code § 13-2 sets a fire-lane sign at 6 feet 6 inches above finished grade, on a permanently affixed stationary post.

    Does my accessible-space sign have to say “Violators Subject to Fine and Towing”?

    On work that 16 TAC § 68.104 reaches — new construction and alterations beginning on or after 1 August 2020 — yes, that wording is the minimum. It does not have to be a separate sign: § 68.104(b) says an identification sign meeting TAS 502.6 that includes the wording satisfies the requirement by itself. If your existing sign already carries it, nothing more is needed. If it does not, it is a replacement face or a plaque mounted below it.

    What exactly does a fire-lane sign have to say and look like?

    The Fort Worth Fire Code § 13-2 specifies it to the inch. The sign reads “NO PARKING FIRE LANE,” 12 inches wide by 18 inches high, with a companion “TOW AWAY ZONE” sign 12 by 6. White background, letters and borders in red, lettering not less than 2 inches, permanently affixed to a stationary post with its bottom 6 feet 6 inches above grade.

    Do I need a city permit to install parking lot signs?

    Confirm that with the City of Fort Worth for your address before installation. Sign regulation runs through the Fort Worth Code of Ordinances, and what it requires varies by sign type and location. We will not tell you a permit is or is not required for a regulatory parking-lot sign. That is the city’s call.

    Do I have to replace faded or damaged signs?

    For fire-lane signage, yes. Section 503.3 of the Fort Worth Fire Code requires signs and striping “be maintained in a clean and legible condition at all times and be replaced or repaired when necessary to provide adequate visibility.” For accessible spaces there is a sharper reason: a missing or non-compliant sign is what stops an officer citing a vehicle parked in that space.