Parking Lot Sign Installation
In East Louisville, KY
ADA, Fire Lane, and Directional Signage
1-800-STRIPER provides professional parking lot sign installation in East Louisville, KY — setting accessible-space signs with the International Symbol of Accessibility, van-accessible designations, fire lane no-parking signs, and directional signage per the 2010 ADA Standards for Accessible Design.
1-800-STRIPER of East Louisville PROVIDes Parking Lot Sign Installation Services NEAR YOU
Are you communicating clearly?
We install new signs in adherence with local regulatory standards and can repair or replace damaged signs so you can clearly communicate your parking requirements.
Parking Lot Sign Installation in East Louisville, KY
Signs are the half of a parking lot that striping cannot do. Pavement markings tell a driver where to put the car; signs tell them what the space is for and what happens if they get it wrong.
We supply and install accessible parking signs, fire lane signage, directional and wayfinding signs, reserved and tenant signage, and speed and stop signage on commercial properties across the region. Most of it goes in alongside a striping visit, because the sign and the stall it governs should be laid out together.
Accessible Parking Signs
Accessible spaces have to be identified by a sign carrying the International Symbol of Accessibility — with two narrow exceptions in section 216.5: sites with four or fewer total parking spaces, and residential facilities where spaces are assigned to specific dwelling units. Everything else about those spaces still applies, including the access aisle and the dimensions.
Section 502.6 of the 2010 ADA Standards is precise about the height, and it is precise in a way people misquote: signs shall be 60 inches minimum above the finish floor or ground surface, measured to the bottom of the sign. A minimum, not a fixed height. Measured to the bottom, not the center and not the top. Spaces that are van spaces carry an additional “van accessible” designation, which Advisory 502.6 describes as informative, not restrictive — it identifies the space, it does not reserve it exclusively.
Fire Lane and No-Parking Signs
Fire lane signage in this jurisdiction has a real local specification, which is unusual and useful.
Louisville Metro Code § 94.82(E)(2)(b) specifies, where a fire lane is required, that NO PARKING FIRE LANE signs be mounted at heights not less than 36 inches nor greater than 96 inches, measured from the bottom of the sign, and positioned at intervals not greater than 60 feet. Both a band and a maximum spacing, written down.
Where signs cannot be placed, the ordinance allows a painted legend instead — but only on prior approval from the Building Official. We cover that specification on the fire lane striping page.
Directional and Wayfinding Signs
Entry and exit designation, one-way arrows, stop and yield signage at internal intersections, speed signage, loading zone and dock signage, reserved and visitor parking, and tenant identification.
One point worth stating plainly, because it has two halves. Kentucky’s traffic-control regulation, 603 KAR 5:050, incorporates the Manual on Uniform Traffic Control Devices, 11th edition, December 2023, and applies it to any private road open to public travel. A parking area and the driving aisles within it are expressly excluded — so on the parking field itself, MUTCD sign designs are a design convention rather than a mandate. But the same definition reaches privately owned roads within a shopping center, airport, sports arena or similar facility where the public travels without access restrictions, and on those the manual is the state’s standard. We will tell you which surface yours is before we tell you what the manual requires — and we follow MUTCD designs on both, because a driver recognizes a standard sign faster than a custom one.
Mounting, Posts, and Placement
| Sign | Must carry | Height | Spacing |
|---|---|---|---|
| Accessible space | International Symbol of Accessibility | 60 in minimum, measured to the bottom | — |
| Van accessible space | Symbol plus “van accessible” designation | Same | — |
| Fire lane | NO PARKING FIRE LANE | Not less than 36 in, not greater than 96 in, from the bottom | Intervals not greater than 60 ft |
Posts go into asphalt or concrete with a sleeve or a direct-set footing depending on the surface and the exposure. Wall and bollard mounting works where a post would obstruct a walkway or an accessible route. Placement always accounts for the parked vehicle: a sign a truck hides is a sign that is not doing its job.
For a full list of our pavement marking services, visit our parking lot striping in East Louisville page.
Businesses We Serve
How it Works
GET A FREE ESTIMATE
Contact us today and we’ll have a quote to you in 24 hours
SCHEDULE AN INSTALLATION
We’ll have your installation scheduled in less than 7 days, without affecting your business hours
GET A PARKING LOT THAT POPS
For a budget-friendly price, you’ll get a parking lot that looks like new
We proudly work with:
We proudly work with:
Frequently Asked Questions About Parking Lot Sign Installation in East Louisville, KY
What has to be on an accessible parking sign, and where does it go?
Section 502.6 of the 2010 ADA Standards sets both. The sign carries the International Symbol of Accessibility, and a van space carries an additional “van accessible” designation. It mounts 60 inches minimum above the finish floor or ground surface, measured to the bottom edge rather than the center. The Access Board explains what that minimum is for — the sign has to stay readable while a vehicle is parked in the space — so on a sloped or curbed approach the placement decision and the height decision are the same decision. We set the post where the sign stays visible from the drive aisle, not just where it measures correctly.
Which spaces need a “van accessible” sign?
The van spaces. Section 208.2.4 of the 2010 ADA Standards requires one van space for every six, or fraction of six, spaces required to be accessible, so a lot with one required accessible space needs that one to be van accessible. Advisory 502.6 notes that the designation is informative, not restrictive — it identifies the space as suitable for a van, it does not reserve it exclusively for one.
Do fire lane signs have to match a specific design?
In this jurisdiction the wording and the mounting are specified. Louisville Metro Code § 94.82(E)(2)(b) calls for NO PARKING FIRE LANE signs at heights not less than 36 inches and not greater than 96 inches measured from the bottom, at intervals no greater than 60 feet. Beyond that the arrangement is approved by the Building Official in cooperation with the Fire Chief, so the district covering your address is the authority worth confirming with.
Can you install signs on concrete, asphalt, or a wall?
All three. Posts set into asphalt or concrete using a sleeve or a direct-set footing, chosen for the surface and the exposure, and wall or bollard mounting where a post would obstruct a walkway or an accessible route. Which method suits a given location depends on the surface, on what is underneath it, and on whether the sign sits in a plow path. We check the anchor point before installing rather than after.
Do you replace damaged or faded signs?
Yes, and it is worth doing on a schedule instead of waiting for a complaint. Sun exposure dulls the reflective face over time, impact bends posts, and a sign that has faded past legibility is not performing the function it was installed for. Accessible parking signage and fire lane signage matter most here, because both are the kind of thing an inspector or a complaint will surface. We can survey what you have and give you a replacement list.