Parking Lot Sign Installation
In Columbus, OH
Sign Installation Services
1-800-STRIPER® provides professional parking lot sign installation in Columbus, OH — installing ADA R7-8 accessible-space signs, fire lane “No Parking” signs, directional signage, and tow-away warning signs per the 2010 ADA Standards for Accessible Design, Ohio Fire Code, and Columbus City Code Chapter 3312 for commercial properties throughout Franklin County.
1-800-STRIPER® of Columbus PROVIDes Signage Installations Services NEAR YOU
Are you communicating clearly?
We install new signs in adherence with local regulatory standards and can repair or replace damaged signs so you can clearly communicate your parking requirements.
How It Works
Signs fail for three reasons: wrong face, wrong height, wrong footing. Our process prevents all three:
- Scope intake. We identify every required sign category against the site plan, Columbus City Code Chapter 3312 off-street parking dimensions, the Ohio Fire Code fire-lane posting requirements, and the 2010 ADA Standards accessible-stall signage minimums.
- Face selection. We specify reflective aluminum signs with engineer-grade or high-intensity sheeting so the face remains visible at night and in low winter light, and we confirm the legend matches the current edition of the specifying code.
- Mounting height verification. We mount every accessible-stall sign with the bottom of the sign at least 60 inches above grade so it remains visible when a vehicle is parked in the stall, and we mount fire lane signs at compliant heights specified by the Columbus Division of Fire.
- Post and footing. We set 2-inch square galvanized steel posts or round U-channel posts in concrete-filled footings at least 24 inches deep — below the typical Central Ohio frost line — so winter freeze-thaw cycles do not lift or tilt the post.
- Plaque and hardware check. We confirm Van Accessible plaques are installed on van-designated stalls, tow-away plaques are installed where enforcement applies, and all fasteners are anti-rotation so signs cannot be turned by wind or tampering.
- As-built documentation. We leave a site map identifying every installed sign category and location, which supports site plan close-out and future refresh scheduling.
Why Choose Us
Post-and-face sign systems have a longer service life than pavement markings. Reflective aluminum usually holds compliant reflectivity for 7 to 10 years in Columbus before the sheeting degrades. The posts themselves, however, can bend or rust at grade from snow-plow blade contact or winter road salt spray. 1-800-STRIPER® of Columbus walks every Columbus property at annual restriping time, catches faded faces, leaning posts, missing Van Accessible plaques, and plow-damaged signs before they become a compliance gap, and replaces them on the same mobilization as the paint refresh. For graphics-permitted signage governed by the Columbus Graphics Code administered by Building and Zoning Services, we coordinate with the permit process so the installed sign matches the approved application. Regulatory signage inside a parking area is usually installed against the approved site plan instead of a separate graphics permit, so our refresh-and-replace scope can move in the same mobilization as the paint work. For most Columbus commercial properties, that means no additional permit window to schedule around.
Graphics Permit vs. Regulatory Signage in Columbus
A common Columbus property-management question is which parking lot signs require a separate permit and which do not. Freestanding business identification signs and monument signage fall under the Columbus Graphics Code — City Code Chapter 3377 administered by the Department of Building and Zoning Services, and that code normally requires a graphics permit covering sign face area, mounting location relative to the right-of-way, and any illumination. Regulatory signage installed inside an approved parking area, by contrast, gets treated as part of the approved parking layout. ADA R7-8 accessible-space signs, fire lane “No Parking” signs, stop signs, yield signs, one-way directional signs, and tow-away warning signs usually go in against the site plan without a separate graphics permit. For properties under construction, undergoing a use change, or completing a tenant-improvement buildout, we recommend confirming specifics with Building and Zoning Services before installation so nothing stalls plan close-out.
—
For a full list of our pavement marking services, visit our parking lot striping in Columbus page.
Businesses We Serve
How it Works
GET A FREE ESTIMATE
Contact us today and we’ll have a quote to you in 24 hours
SCHEDULE AN INSTALLATION
We’ll have your installation scheduled in less than 7 days, without affecting your business hours
GET A PARKING LOT THAT POPS
For a budget-friendly price, you’ll get a parking lot that looks like new
We proudly work with:
We proudly work with:
Frequently Asked Questions About Parking Lot Sign Installation in Columbus, OH
What signs are required for a parking lot in Columbus, OH?
Commercial parking lots in Columbus, Ohio typically need ADA accessible-space signage (R7-8 with “Van Accessible” plaques where applicable), fire lane “No Parking” signs at posted intervals, directional signs (one-way, stop, yield), reserved-space or tenant-parking signs, and tow-away warning signs where private enforcement applies. Columbus site plan review commonly requires these sign locations on the submitted plan. 1-800-STRIPER® of Columbus installs, replaces, and refreshes all categories of parking lot signage across Central Ohio commercial properties.
Do parking lot signs require a permit in Columbus?
It depends on the sign type. Freestanding business identification signs fall under the Columbus Graphics Code administered by the Department of Building and Zoning Services and typically require a graphics permit. Regulatory signage installed inside a parking area — ADA R7-8 signs, fire lane signs, stop and directional signs — is generally considered part of the approved parking layout and does not require a separate graphics permit, but must still be installed per the site plan and applicable code. Confirm specifics with Building and Zoning Services before installation.
What are ADA signage requirements for accessible parking spaces?
Per the 2010 ADA Standards for Accessible Design, every accessible parking space must be identified by an R7-8 sign displaying the International Symbol of Accessibility, mounted so the bottom of the sign is at least 60 inches above the ground so it remains visible when a vehicle is parked. Van-accessible spaces require an additional “Van Accessible” plaque. In Ohio, these signs must be installed on posts or permanent fixtures rather than painted only on the pavement.
What materials and post depth are used for parking lot sign installation?
Parking lot signs in Columbus are typically installed on 2-inch square galvanized steel posts or round U-channel posts set in concrete-filled footings. In Central Ohio, post footings are normally set at least 24 inches deep — below the typical frost line — to prevent frost heave during winter freeze-thaw cycles. Signs themselves are reflective aluminum meeting MUTCD engineer-grade sheeting standards so they remain visible at night and in low-light winter conditions.
What signage is required to post a fire lane in Columbus?
Under the Ohio Fire Code, designated fire lanes must be posted with “No Parking — Fire Lane” signs at the start and end of each lane and at regular intervals along longer runs — commonly every 50 feet. The Columbus Division of Fire can confirm required spacing and wording for a specific property. Fire lane signs must be installed at compliant mounting heights and paired with painted curb and pavement markings so both visual and posted notice are present.
How long do installed parking lot signs last in Central Ohio?
Reflective aluminum signs with engineer-grade or high-intensity sheeting typically last 7 to 10 years in Columbus before reflectivity degrades below compliance levels. Posts generally last much longer, though they can bend or rust at grade from snowplow contact or road salt exposure. An annual walk-through each spring catches faded faces, leaning posts, missing hardware, or plow-damaged signs before they create liability or compliance gaps. —